I V . A S S E M B L Y
Seat Installation
The standard seat installation method incorporates the seat frame and four adjustable seat posts located on the power base.
WARNING! Do not pick up the seat frame by the armrests. They are free to pivot, and you may lose control of the seat if they do so.
To install the seat: |
|
|
| |
1. | Make sure the power chair is in drive mode. See |
| ||
| figure 8. |
|
|
|
2. | Remove the quick release pins from each of the |
| ||
| four seat towers. See figure 9. |
|
| |
3. | Set the seat on the seat towers. |
|
| |
4. | Install the quick release pins back into the seat |
| ||
| towers. |
|
|
|
5. | Install the controller into the desired armrest. |
| ||
6. | Plug the controller harness into the connector on |
| ||
| the electronics tray. |
|
| WIRE TIES |
7. | Route the controller harness so that it cannot be |
| ||
| pinched in the seat hinge. |
|
| |
| MANDATORY! | Prevent | controller |
|
| harness damage! Avoid routing the |
| ||
| controller harness on the outside of |
| ||
| the armrest pad. Route the harness |
| ||
| under the armrest or toward the inside |
| ||
| of the armrest pad. Use correct tie- |
| ||
| down points for the controller harness |
| ||
| to prevent the harness from getting |
| ||
| caught in the drive tires, pinched in | Figure 10. Controller Harness Routing | ||
| the seat frame, or damaged when |
| ||
| passing through doorways. |
|
| |
8.Secure the controller harness to the armrest receiver with one or more wire ties. See figure 10.
Jazzy 1170 XL Plus Series | www.pridemobility.com | 21 |
