Pride Mobility 1400 owner manual To adjust the anti-tip wheels, Anti-Tip Bracket

V I . C O M F O R T A D J U S T M E N T S

To adjust the anti-tip wheels:

1.Place a 1/2-in. spanner on the inner locknut of the anti-tip bracket located right after your shock strut. See figure 28.

2.Turn locknut counterclockwise to loosen.

3.Place your 1/2-in. spanner on the adjustable camlocated on the other side of the locknut.

4.To adjust the anti-tip upward, turn the cam counterclockwise. To adjust the anti-tip downward, turn the cam clockwise. See figure 29.

NOTE: Each drive tyre must have at least 30 lbs. of air pressure in order for the anti-tip wheels to be properly adjusted.

NOTE: The higher you raise the anti-tip wheels, the more tendency your Jazzy has to tilt forward when coming to a stop. You can compensate for this by making a small adjustment to the pre-programmed deceleration setting in the controller or by moving the seat assembly further to the rear of your Jazzy.

Figure 28. Anti-Tip Bracket

Figure 29. Anti-Tip Wheel Adjustment

Jazzy 1400/Rev C/Sept02 www.pridemobility.com 23