Pride Mobility 1400 Foot Platform Depth, To adjust the foot platform depth, Controller Position

	V . C O M F O R T A D J U S T M E N T S
NOTE: If the lever will not rotate to the fully closed
position, then turn the nut counterclockwise one-quar-
ter or one-half turn.		ARMREST KNOB
		(LOCATED ON
Armrest Width Adjustment		SEAT FRAME)
Youcanchangeeacharmrest’swidthindependentlyoftheother.
NOTE: Changing the armrest width may increase the
overall width of your Go-Chair.
To change the armrest width:
1.	Locate the two armrest knobs on each side of the
	armrest receiver bracket. See figure 18.
2.	Loosen the knobs.
3.	Slide the armrests in or out to the desired width.
4.	Tighten the knobs.	Figure 18. Armrest Width Adjustment

Foot Platform Depth

To adjust the foot platform depth:

1.Remove the hardware from the footplatform bracket. See figure 19.

2.Move the foot platform in or out to the desired depth.

3.Reinstall the hardware into the foot platform bracket

and tighten.

Controller Position

You can position the controller for either left-hand or right- hand use.

WARNING! Do not place the controller
cable so that it can be pinched in the
seat frame or the power base frame.	Figure 19. Foot Platform Depth

To change the controller position:

1.Unplug the controller connector from the power base.

2.Cut the wire tie(s) securing the controller cable to the armrest.

3.Flip up the armrest and loosen the setscrew. See figure 20.

4.Slide the controller out of the armrest.

5.Loosen the setscrew in the other armrest.

6.Place the controller in the other armrest.

7.Tighten the setscrew to secure the controller.

8.Use a wire tie to secure the controller cable to the armrest.

9.Plug the controller connector into the power base.

SETSCREW

Figure 20. Controller Position

Go-Chair www.pridemobility.com 23