Pride Mobility 1400 owner manual Wheel Replacement, To replace the wheel, Battery Replacement

V I I I . C A R E A N D M A I N T E N A N C E

WARNING! Never use any chemicals to clean a vinyl seat, as they may cause the seat to become slippery or dry out and crack. Use soapy water and dry the seat thoroughly.

Wheel Replacement

If your chair is equipped with a solid tire insert, then you must replace the whole wheel assembly. Replacement wheel as- semblies are readily available through an authorized Pride Provider.

WARNING! To avoid possible injury, be sure that the controller’s power is turned off and the Go-Chair is not in freewheel mode before performing this procedure.

To replace the wheel:

1. Turnoffthepowertothecontroller.

2. Set the Go-Chair up on blocks.

3. Removethedrivewheelnutfromthewheelhub.Seefigure24.

4. Pullthewheelofftheaxle.

5. Slide the new wheel back onto the shaft. Make sure that the keyisintheaxleslot.

6.Reinstallthedrivewheelnutontothewheelhubandtighten.

7.Remove the Go-Chair from the blocks.

Battery Replacement

Figure 24. Go-Chair Drive Wheel

A battery wiring diagram is printed on a decal located on the front battery tray. See the Specifications Table for correct battery specifications.

WARNING! Prevent injury. Do not replace battery when seat is occupied.

WARNING! Battery posts, terminals, and related accessories contain lead and lead compounds. Wear goggles and gloves when handling batteries and wash hands after handling.

WARNING! Go-Chair batteries are heavy. See specifications table. If you are unable to lift that much weight, be sure to get help. Lifting beyond your capacity can result in personal injury.

To replace the batteries:

1.Remove the battery box from the Go-Chair.

2.Turn the pack upside down.

3.Remove all screws that hold the battery box halves together. See figure 25.

4.Flip the battery box back over so the handle is up and remove the lid.

5.Remove the red (+) positive and black (-) negative battery leads from each battery.

6.Remove the batteries.

7.Put the new battery or batteries back into the battery box (battery terminals up).

8.Reconnect the two (2) battery leads to the battery terminals. Make sure the red lead is connected to the (+) positive terminal and the black lead is connected to the (-) negative terminal.

9.Replace the lid and carefully flip the battery box over so the handle is down.

10.Replace and tighten all the screws that hold the battery box together.

11.Reinstall the battery box back onto the Go-Chair.

34 www.pridemobility.com Go-Chair