Pride Mobility 1400 owner manual Seat Installation, To install the seat, Disassembly, Assembly

I V . A S S E M B L Y / D I S A S S E M B L Y

SEAT INSTALLATION

It may be necessary to install the seat either prior to initial operation or after transporting your Go-Chair. The seat is attached to the power base by a height-adjustable seat pedestal.

WARNING! Do not pick up the seat frame by the armrests. They are free to pivot, and you may lose control of the seat if they do so, resulting in personal injury or damage to the chair.

To install the seat:

1.Adjust the seat height if necessary. See V. “Comfort Adjustments.”

2.Set the seat onto the seat pedestal. See figure 9.

3.Install the controller into the armrest, and tighten the setscrew under the armrest.

4.Plug the controller connector into the power base. See figure 6.

DISASSEMBLY

The Go-Chair disassembles into four components: the seat, the battery box, the rear section of the power base and the front section of the power base. See figure 10.

To disassemble the Go-Chair:

1.Turn off power to the controller. SeeVII. Operation.

2.PlacetheGo-Chairindrivemode.SeeIII.“YourGo-Chair.”

3.Disconnect the controller from the power base.

4.Remove the seat.

5.Graspthebatteryboxhandleandliftuptodisengagethebox fromthepowerbase,thentilttheboxforwardslightlyandpull it away from the power base.

6.Pushinthetogglelatchreleasebuttonwhilepullingforward on the toggle latch. See figure 11.

7.Rotatethetogglelatchbuckleoverthetopofthetogglelatch untilitsnapsintoitsretainer.Seefigure12.

8.Lift the front section up and off of the rear section.

ASSEMBLY

1.Tilt the Go-Chair rear section rearward onto the anti- tip wheels. See figure 13.

2.While holding the front section parallel to the floor, align the curved locking brackets on the front section with the corresponding pegs on the rear section. See figure 14.

Figure 9. Seat Installation

Figure 10. Go-Chair Components

20 www.pridemobility.com Go-Chair