Pride Mobility 6000 manual Power Elevating Seat Optional

V . C O M F O R T A D J U S T M E N T S

Power Elevating Seat (Optional)

If your power chair is equipped with a power elevating seat, you can change the seat height either through the controller or through a toggle switch mounted to one of the armrests.

To change the seat height through toggle switch:

1. Press forward on the toggle switch to raise the seat. See figure 23.

2. Pull back on the toggle switch to lower the seat.

WARNING! Do not allow the motor to run more than a few seconds after the mechanism reaches the top or bottom limit.

NOTE: For more information on operating the power elevating seat through the controller, contact your Quantum Rehab Provider.

WARNING! The power elevating seat option is intended for use on a level surface only. Never raise the seat from

its lowest position on an inclined
surface. Failure to heed this warning
				Figure 23. Power Elevating Seat Toggle Switch
can result in the power chair tipping
over.
WARNING! Never raise the seat from
its lowest position when operating
your power chair on bumpy or uneven
surfaces. Failure to heed this warning
can result in the power chair tipping
over.
WARNING! Never raise the power
elevating seat while your power chair
is in the freewheel mode.
WARNING!	Always	fasten	the
positioning	belt when	operating	the

power elevating seat.

NOTE: The power elevating seat option is equipped with a system that reduces the speed of the power chair by one half when the seat is elevated more than 1–2 in. (2.5–5 cm). Always check to be sure this sys- tem is operating properly before using your power chair.

Quantum 6000 Series www.pridemobility.com 29