V I I . C A R E A N D M A I N T E N A N C E
To replace the batteries:
1.Turn off the power to the controller.
2.Make sure that the power chair is in drive mode. See III. “Your Power Chair.”
3.Remove the foot platform by squeezing the release handles (see figure 27) and lifting the foot platform bracket up and away from the power base.
4.Disconnect the quick release battery connectors. See figure 7.
5.Remove the batteries.
6.Disconnect the battery harness from each battery.
7.Connect the battery harness to the new front battery according to the battery wiring diagram. See figure 27.
WARNING! Make sure you tighten the fasteners so that the connections are secure.
8.Connect the battery harness to the new rear battery according to the battery wiring diagram. See figure 27.
9.Install the new batteries.
10.Reinstall the front cover and foot platform.
11.Charge the batteries. See VI. “Batteries and Charging.”
| BATTERY WIRING DIAGRAM LABEL |
REAR SHROUD FASTENER | REAR SHROUD |
| |
(OPPOSITE SIDE NOT SHOWN) | FRONT COVER |
| RELEASE HANDLES |
| FRONT BATTERY |
| REAR BATTERY |
Figure 27. Battery Installation
38 | www.pridemobility.com | Quantum 6000 Series |
