V I . B A T T E R I E S A N D C H A R G I N G

To charge the batteries using the off-board charger:

 

1.

Position your power chair next to a standard electrical

 

 

outlet.

 

2.

Be certain the controller power is turned off and the

 

 

power chair is in drive mode.

 

3.

Plug the off-board charger into the off-board charger/

 

 

programming socket on the controller. See figure 24.

 

4.

Plug the off-board charger into the electrical outlet.

 

NOTE: If it is a Pride off-board charger, then there are

 

two lights in it. The red light indicates that power to the

 

off-board charger is on. The green light indicates that the

 

batteries are fully charged. If it is not a Pride off-board

 

charger, then follow the instructions supplied by the

 

manufacturer.

 

5.

When the batteries are fully charged, unplug the off-

Figure 24. Battery Charging

 

board charger from the electrical outlet and then from

the controller.

Battery Break-in

To break in new batteries for maximum efficiency:

1.Fully recharge any new battery prior to its initial use. This brings the battery up to about 90% of its peak performance level.

2.Operate your power chair throughout the house and yard. Move slowly at first, and do not travel too far until you become accustomed to the controls and break in the batteries.

3.Give the batteries another full charge of 8 to 14 hours and operate your power chair again. The batteries will now perform at over 90% of their potential.

4.After four or five charging cycles, the batteries will top off at 100% charge and last for an extended period.

Frequently Asked Questions (FAQs)

How does the charger work?

The battery charger takes the standard electrical outlet voltage of 120 VAC (alternating current) and converts it to 24 VDC (direct current). The power chair batteries use direct current to run your power chair. When the battery voltage is low, the charger works harder to charge the battery. As the battery voltage approaches full charge, the charger does not work as hard to complete the charging cycle. When the battery is fully charged, the amperage from the charger is nearly at zero. This is how the charger maintains a charge but does not overcharge the battery.

Can I use a different battery charger?

You should use the charger supplied with the power chair. It is the safest, most efficient tool to charge the batteries. We do not recommend using other types of chargers (e.g., an automotive battery charger).

NOTE: Your power chair’s charger will not operate after the batteries have been discharged to nearly zero voltage. If this happens, call your Quantum Rehab Provider for assistance.

How often must I charge the batteries?

Many factors come into play when deciding how often to charge the batteries. You may use your power chair all day on a daily basis or you may not use it for weeks at a time.

Quantum 6000 Series

www.pridemobility.com

31

Page 31
Image 31
Pride Mobility 6000 manual Battery Break-in, Frequently Asked Questions FAQs