Pride Mobility 610 owner manual V . C O M F O R T A D J U S T M E N T S, Comfort Adjustments

V . C O M F O R T A D J U S T M E N T S

COMFORT ADJUSTMENTS

After becoming familiar with your power chair’s operation, you may find the need to make some adjustments to increase your comfort, such as seat height and angle, armrest angle, foot platform height and angle, and controller position. If your power chair is equipped with a medium-back, a high-back, or a reclining seat, refer to the following information.

WARNING! If your power chair was configured by your authorized Pride Provider, please consult your healthcare professional before changing the seat position or making any other adjustment. Some adjustments may degrade your power chair’s performance and safety by changing its center of gravity.

WARNING! Some power chair components are heavy. You may need assistance to lift or carry them. Please refer to the specifications table for specific component weights before you disassemble the power chair.

WARNING! Prevent injury. Remove the occupant from the power chair before making any adjustments.

You may need the following to make comfort adjustments:

!metric/standard socket set and ratchet

! adjustable wrench

!thread lock

Seat Height and Seat Angle Adjustment
You can change the seat height to one of four positions in 1-
in. increments by raising the front and rear trapeze bars. If
you raise or lower only one trapeze bar (front or rear), you
can also change the seat base angle (dump).	Figure 12. Seat Height Adjustment - Seat Latch Safety

To change the seat height:

1.Turn off the power to the controller.

2.Unlock the rear shroud fasteners and remove the rear shroud. See figure 6.

3.Disconnect the controller connector(s) from the power base. See figure 7.

4.Flip up the seat latch safety. See figure 12.

5.Squeeze the seat latch and release the seat from the front trapeze bar. See figure 12.

6.Slide the seat forward and remove it from the power base.

7.Loosen the screws that attach the trapeze bars to the seat posts. See figure 13.

8.Remove the retaining clips that secure the seat posts to the power base. See figure 13.

9.Move the trapeze bars up or down to the desired height.

NOTE: Change the seat dump by raising or lowering only one set of towers (front or back).

10. Reinstall the retaining clips from step 8.

SCREWS

TRAPEZE BARS

SEAT POSTS

SEAT POSTS

RETAINING

CLIPS

RETAINING

CLIPS

Figure 13. Seat Height Adjustment - Trapeze Bars

22 www.pridemobility.com Jazzy 610