| V . C O M F O R T A D J U S T M E N T S | ||
Armrest Width Adjustment |
| ||
Youcanchangeeacharmrest’swidthindependentlyoftheother. |
| ||
NOTE: Changing the armrest width may increase the | FOOT PLATFORM | ||
overall width of your power chair. | |||
RETAINING PIN | |||
|
| QUICK RELEASE | |
To change the armrest width: | FASTENERS | ||
| |||
1. | Locate the two armrest knobs on each side of the arm- | FOOT | |
| rest receiver bracket. See figure 15. | ||
| PLATFORM | ||
2. | Loosen the knobs. | BRACKET | |
3. | Slide the armrests in or out to the desired width. | SECUREMENT | |
4. | Tighten the knobs. | NUT | |
| |||
Armrest Angle Adjustment |
| ||
To change the armrest angle: |
| ||
1. | Lift the armrest straight up so that it is perpendicular to |
| |
| the floor. See figure 15. |
| |
2. | Loosen the jam nuts. |
| |
3. | Turn the adjusting screw clockwise to raise the front of | Figure 16. Foot Platform Adjustment | |
| the armrest, or turn the adjusting screw counterclock- |
| |
| wise to lower the front of the armrest. |
| |
4.Tighten the jam nuts to lock the adjusting screw into place.
LEVER (FULLY CLOSED)
Foot Platform Height Adjustment | CAM | |
The foot platform height is easily adjusted to different heights | ||
NUT | ||
in | ||
BOLT |
To raise or lower the foot platform:
1.Remove the quick release fasteners from the foot plat- form bracket. See figure 16.
2. | Loosen the foot platform securement nut by | UNCLAMPED | CLAMPED |
|
| ||
| turn. |
|
|
3. | Raise or lower the foot platform to the desired height. | LEVER (OPEN) |
|
4.Reinstall the quick release fasteners into the foot plat- form bracket and tighten.
5. Tighten the foot platform securement nut. | Figure 17. Quick Release Fastener Operation |
|
Foot Platform Depth Adjustment
To adjust the foot platform depth:
1.Remove the quick release fasteners from the foot platform bracket. See figure 16.
2.Move the foot platform in or out to the desired depth.
3.Reinstall the quick release fasteners into the foot platform bracket and tighten.
Quick Release Fasteners: The foot platform is attached to the power base with two quick release fasteners. See figure
16.Each quick release fastener consists of a bolt, a lever, and a nut. See figure 17. The lever has a cam on the end that allows it to clamp into place. The quick release fastener has two states: clamped and unclamped. When the lever is open,
24 | www.pridemobility.com | Jazzy 610 |
