Pride Mobility INFMANU3351 manual A S S E M B L Y, Initial Assembly

I V . A S S E M B L Y

INITIAL ASSEMBLY

Your power chair may require some assembly either before initial use or after transportation.

NOTE: Any nylon insert lock nut removed during the disassembly or adjustment of the power chair must be replaced with a new nylon insert lock nut. Nylon insert lock nuts should not be reused as it may cause damage to the nylon insert, resulting in a less secure fit. Replacement nylon insert lock nuts are available at local hardware stores or through your authorized Pride Provider.

Seat Installation (Select and Select 6 only)
It may be necessary to install the seat either prior to
initial operation or after transporting your power chair.
WARNING! Do not pick up the seat
frame by the armrests. They are free
to pivot, and you may lose control of
the seat if they do so.
To install the seat:
1. Slide the seat down onto the power base. See fig-			WIRE
ure 13.			TIES
2. Install the controller into one of the armrests.
Tighten the setscrew with the supplied hex key.			SEAT
See figure 13.
3. Lift the armrest straight up, then route the con-			CONTROLLER
troller harness and secure with wire ties as shown
in figure 13.			SETSCREW
NOTE: It is important that the armrest be lifted
straight up prior to securing the controller harness
with wire ties.
MANDATORY!	Prevent	controller
harness damage! Avoid routing the
controller harness on the outside of
the armrest pad. Route the harness
under the armrest or toward the
inside of the armrest pad. Use
correct tie-down points for the
controller harness to prevent the			POWER BASE
harness from getting caught in the
drive tires, pinched in the seat
frame, or damaged when passing
through doorways.			Figure 13. Seat and Controller Assembly

4.Plug the controller harness into the connector on the power base. See figure 6 or 7.

Jazzy Select Series www.pridemobility.com 23