V I I . C A R E A N D M A I N T E N A N C E
MOTOR |
| KEY | DRIVE WHEEL |
|
|
| |
|
|
| DRIVE WHEEL NUT |
| AXLE |
| HUB CAP |
|
|
| |
|
| DRIVE WHEEL WASHER | |
WARNING! Completely deflate the tire before attempting repair. | |||
Figure 27. Jazzy Select 6 and Select 6 with Power Seat Drive Wheel Removal
MOTOR | KEY | DRIVE WHEEL |
| ||
|
| |
AXLE |
| DRIVE |
|
| WHEEL NUT |
|
| DRIVE WHEEL WASHER |
Figure 28. Jazzy Select Drive Wheel Removal
WARNING! The wheels on your power chair should only be serviced or replaced by an authorized Pride Provider or a qualified technician.
WARNING! Be sure that the power to the controller is turned off and the power chair is not in freewheel mode before performing this procedure.
WARNING! When changing a tire, remove only the center lug nut and washer, then remove the wheel. If any further disassembly is required, deflate the tire completely or it may explode.
Follow these easy steps for a quick and safe repair for both pneumatic and solid tires:
1.Turn off the power to the controller.
2.Make sure that the power chair is in drive mode. See figure 11.
3.Raise and support the power base so that the wheel is at least 1 in. (2.5 cm) off of the ground.
4.If you are changing a pneumatic tire, completely deflate it before removing the wheel.
5.Remove the hub cap, if equipped. See figure 27.
6.Remove the drive wheel nut and washer from the axle. See figure 27 or 28.
7.Remove the drive wheel from the axle. Make sure that you keep the key.
8.Remove the acorn nuts that fasten the two rim halves together.
9.Remove the old tube from the pneumatic tire and replace it with a new tube or replace the entire assembly if it is a solid tire.
10.Reassemble the two rim halves.
11.Slide the wheel back onto the axle. Make sure that the key is in the axle slot.
WARNING! Failure to ensure that the axle key is properly installed into the axle slot when mounting the wheel can result in electronic brake failure, personal injury, and/or product damage.
12. Reinstall the drive wheel nut and washer onto the axle and tighten. See figure 27 or 28.
WARNING! Make sure both the nut and washer are reinstalled and tightened properly.
13.Reinstall the hub cap, if equipped.
14.Inflate the pneumatic tire to the psi/bar/kPa air pressure rating indicated on each tire.
15.Remove the power chair from the base support.
40 | www.pridemobility.com | Jazzy Select Series |
