I V . A S S E M B L Y
Seat Installation (Select 6 with Power Seat only)
It may be necessary to install the seat either prior to initial operation or after transporting your power chair. Most seats are attached to the power base with the Uni- versal Mounting System (UMS). The UMS consists of universal parts that may be attached to any medium- back or
WARNING! Do not pick up the seat frame by the armrests. They are free to pivot, and you may lose control of the seat if they do so.
To install the power seat:
1.Tilt the seat back and slide the rear extrusion onto the power seat base.
2.Lower the front extrusion onto the power seat base until the seat locks into place.
3.Flip down the seat latch safety. See figure 15.
4.Connect the power seat connector to the power base. See figure 14.
5.Lift the armrest straight up, then route the control- ler harness and secure with wire ties as shown in figure 16.
NOTE: It is important that the armrest be lifted straight up prior to securing the controller harness with wire ties.
MANDATORY! Prevent controller harness damage! Avoid routing the controller harness on the outside of the armrest pad. Route the harness under the armrest or toward the inside of the armrest pad. Use correct tie- down points for the controller harness to prevent the harness from getting caught in the drive tires, pinched in the seat frame, or damaged when passing through doorways.
6.Plug the controller harness into the connector on the power base. See figure 8.
NOTE: Refer to V. “Comfort Adjustments” for more information on controller installation and adjust- ment.
REAR EXTRUSION |
SEAT LATCH |
SAFETY |
FRONT EXTRUSION |
POWER SEAT |
CONNECTOR |
Figure 14. Universal Mounting System on Select 6 with Power Seat
24 | www.pridemobility.com | Jazzy Select Series |
