V I . B A T T E R I E S A N D C H A R G I N G

BATTERIES

The Jazzy uses two long-lasting, 12-volt, deep-cycle batteries. These batteries are sealed and maintenance free. Since they are sealed, there is no need to check the electrolyte (fluid) level. Deep-cycle batteries are designed to handle a longer and deeper discharge. Though they are similar in appearance to automotive batteries, they are not interchangeable.Automotive batteries are not designed to handle a long, deep discharge, and also are unsafe for use in power chairs.

WARNING! Battery posts, terminals, and related accessories contain lead and lead compounds. Wash hands after handling.

CHARGING THE BATTERIES

The battery charger is essential in providing long life for your Jazzy batteries. See figure 3. The battery charger is designed to optimize your Jazzy’s performance by charging the batteries safely, quickly, and easily. The charging system consists of the charger, the charger fuse, and the ammeter. The onboard charger is located underneath the electronics tray. The ammeter is located on the electronics tray for easy viewing. The charger has an in-line fuse that protects the ammeter. The ammeter indicates the rate of charge necessary to fully recharge the batteries. It is also a good indication of whether or not the charger is working. The ammeter and the charger are only functional when the charger power cord is plugged into a wall outlet.

WARNING! Never use an extension cord to plug in your battery charger. Plug the charger directly into a properly wired standard wall outlet.

WARNING! You must recharge your Jazzy’s batteries with the supplied onboard or the optional off- board charging system. Do not use an automotive-type battery charger.

To charge the batteries using the onboard charger:

1.Position the rear of your Jazzy close to a standard wall outlet.

2.Be certain the controller power is turned off and the freewheel levers are in the engaged position. See IV. “The Jazzy 1103.”

3.Remove the battery charger cord from the back pouch of your Jazzy and plug it into the onboard battery charger AC power cord receptacle located on the electronics tray.

4.Extend the chargerAC power cord and plug it into the wall outlet. The Jazzy incorporates an inhibit function that disables the power chair when the charger is plugged into a wall outlet.

5.The ammeter indicates how much charge is needed to fully charge the batteries. Wait about a minute for the charger to warm up. The ammeter may move as high as 5.5 amps, then gradually move back down to 0 amps as the batteries charge.

6.We recommend you charge the batteries for 8 to 14 hours.As the batteries charge, the ammeter needle slowly drops to 0. When the batteries are fully charged, the needle vibrates on or about the 0 mark on the ammeter scale.

7.When your Jazzy’s batteries are fully charged, you can unplug the onboard battery charger AC power cord from the wall outlet, wind it up using the hook and loop strap, and place the cord back into the Jazzy’s back pouch.

24

www.pridemobility.com

Jazzy 1103 Rev L/Feb03

Page 24
Image 24
Pride Mobility Jazzy 1103 owner manual B a T T E R I E S a N D C H a R G I N G, Charging the Batteries