Pride Mobility Jazzy 1103 owner manual Monthly Checks, Yearly Checks, Storage

V I I I . C A R E A N D M A I N T E N A N C E

MONTHLY CHECKS

νCheck that the anti-tip wheels do not rub the ground when you are operate the Jazzy.Adjust them as necessary. See V. “ComfortAdjustments.”

νCheck for extreme wear on the anti-tip wheels. Replace them as necessary.

νCheck for drive tire wear. See an authorized Pride provider for repair.

νCheck the rear casters for wear. Replace them as necessary.

νCheck the rear forks for damage or fluttering which indicates that they may need to be adjusted or have the bearings replaced. See an authorized Pride provider for repair.

νKeep your Jazzy clean and free of foreign material, such as mud, dirt, hair, food, drink, etc.

YEARLY CHECKS

Take your Jazzy to an authorized Pride provider for yearly maintenance. This helps ensure that your Jazzy is functioning properly and helps prevent future complications.

STORAGE

Your power chair should be stored in a dry place, free from temperature extremes. When storing, disconnect the batteries from the Jazzy. See VI. “Batteries and Charging.”

WARNING! If you fail to store the unit properly, the frame can rust and the electronics can be damaged.

CLEANING INSTRUCTIONS

CAUTION! Never hose off your Jazzy or place it in direct contact with water. Your Jazzy has a painted, ABS plastic body shroud that allows it to be easily wiped clean with a damp cloth.

CAUTION! Never use any chemicals to clean a vinyl seat, as they may cause the seat to become slippery or dry out and crack. Use soapy water and dry the seat thoroughly.

TIRE/WHEEL REPLACEMENT

If you have pneumatic tires and you have a flat tire, you may replace the tube. If your chair is equipped with a solid tire insert, then you must replace the whole wheel assembly. Replacement tires, tubes, and wheel assemblies are readily available through your authorized Pride provider.

WARNING! To avoid possible injury, be sure that the controller's power is turned off and the power chair is not in freewheel mode before performing this procedure.

WARNING! Completely deflate the tire before attempting repair.

Follow these easy steps for a quick and safe repair for both solid and pneumatic tires:

1.Turn off the power to the controller.

2.Set the power chair up on blocks.

3.If you are changing a pneumatic tire, completely deflate it before removing the wheel.

4.Use a socket wrench to remove the drive wheel nut from the center hub of the wheel.

5.Pull the wheel off the axle.

Jazzy 1103 Rev L/Feb03 www.pridemobility.com 37