V . C O M F O R T A D J U S T M E N T S
ARMREST WIDTH ADJUSTMENT
To change the armrest width:
1.Locate the two knobs on the armrest receiver bracket. See figure 8.
2.Loosen the knobs; slide the armrests in or out for the desired width.
3.Retighten the knobs.
ARMREST ANGLE ADJUSTMENT
You can adjust the armrest angle to fit your specific needs.
To change the armrest angle:
1.Lift the armrest straight up so that it is perpendicular to the floor.
2.Use a wrench to loosen the jam nuts. See figure 9.
3.Use a hex key to loosen the hex screw. Turn the screw clockwise to raise the front of the armrest and counterclockwise to lower the front of the armrest.
4.Locktheadjustmentscrewintoplacebytighteningthejamnuts.
CONTROLLER EXTENSION ADJUSTMENT
The controller can easily slide out away from the armrest, or in toward the armrest.
To extend the controller:
1.Use a hex key to loosen the setscrew.
2.Slide the controller into or out of the armrest to the desired position. See figure 10.
3.Retighten the setscrew by turning it clockwise.
CONTROLLER POSITION
You can position the controller for either
To change the controller position:
1.Unplug the controller and the charger inhibit connectors from the electronics tray. See figure 4.
2.Cut the wire tie that attaches the controller cable to the armrest. See figure 11.
3.Use a hex key to loosen the setscrew. See figure 9.
4.Slide the controller out of the armrest.
5.Loosen the setscrew in the other armrest.
6.Place the controller in the other armrest.
7.Tighten the setscrew.
8.Use a wire tie to secure the controller cable to the armrest.
9.Plug in the controller and the charger inhibit connectors to the electronics tray.
TURN THIS HEX SCREW TO CHANGE ARMREST ANGLE.
JAM NUTS
LOCK
ADJUSTMENT
SCREW IN
PLACE.
Figure 9. Armrest Angle
LOOSEN THIS
SETSCREW TO
ADJUST
CONTROLLER.
Figure 10. Controller Extension
USE A WIRE TIE TO SUPPORT
THE CONTROLLER CABLE.
Figure 11. Wire Tie Location
Jazzy 1103 Rev L/Feb03 | www.pridemobility.com | 21 |
