Pride Mobility Jazzy 1122 owner manual S S E M B L Y, To install the seat, Joystick Installation

Models: Jazzy 1122

1 56
Download 56 pages 10.78 Kb
Page 22
Image 22

V . A S S E M B L Y

SEAT INSTALLATION (SEAT WITH H-FRAME) Thestandardseatinstallationmethodincorporatestheseatframe(H- frame) and four (4) adjustable seat posts located on the power base.

WARNING! Do not pick up the seat frame by the armrests. They are free to pivot, and you may lose control of the seat if they do so, resulting in personal injury and/or damage to the chair.

To install the seat:

1.Set the seat on the rear seat towers. See figure 10.

2.Push the seat back and down until the latches engage on the front seat towers. See figure 10.

3.Plug the controller cable into the connector on the electronics tray. See figure 11.

4.Plug the power seat switch cable (if so equipped) into the connector on the electronics tray.

5.Secure the controller cable to the armrest receiver with one or more wire ties.

6.Route the cable to ensure that the cable cannot be pinched in the seat hinge.

JOYSTICK INSTALLATION

Depending on the various configurations and options you have chosen for your Jazzy, it may have been shipped without the joy- stick module installed in the armrest.

To install the joystick:

1.Use a 3/16-in. hex key to loosen the setscrew. See figure 12.

2.Slide the joystick mounting bracket into or out of the armrest to the desired position.

3.Retighten the setscrew.

CAUTION! Do not place the controller cable so that it can be pinched in the seat frame or power base frame.

FRONT

 

 

SEAT

REAR SEAT TOWERS

TOWERS

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Figure 10. Seat Towers

CONTROLLER CABLE

Figure 11. Controller Cable Connection

22

WWW.PRIDEMOBILITY.COM

JAZZY 1122/REV D/FEB 03

Page 22
Image 22
Pride Mobility Jazzy 1122 owner manual S S E M B L Y, To install the seat, Joystick Installation, To install the joystick