V I I . O P E R A T I O N
Control Panel
The control panel contains the control buttons and the battery con- dition meter. See figure 23.
Horn Button:Activates the horn.
On/Off Button: Turns the controller on and off.
WARNING! Unless faced with an emergency situation, do not use the on/off key to stop the chair. This will cause the power chair to stop abruptly.
WARNING! Always turn the power off when you are stationary to prevent unexpected movement.
Speed Dial: Controls the power chair speed.
!Turn the dial clockwise to increase the speed.
!Turn the dial counterclockwise to decrease the speed.
NOTE: We recommend that the first few times you operate your power chair, you set the speed to the slowest setting until you become familiar with your new power chair.
Battery Condition Meter: The battery condition meter consists
of five LEDs arranged in an arc over the on/off and horn buttons. See figure 23. The battery condition meter indicates the status of
the electrical system using LED codes. For example, as the battery Figure 23. GC Joystick Module voltage drops, the number of LEDs reduces from right to left. When
the battery capacity drops to 10% or below, the left red LED will flash.
Battery condition meter codes are as follows:
!Left Red LED Flashing: Battery charge is low; Charge the batteries as soon as possible.
!
!
!All LEDs Flashing Quickly: The joystick was not in the center position when the power was switched on, or the controller system detected a fault; refer to the Fault Code Table.
Lock Mode
The controller is equipped with a feature that enables you to “lockout” unauthorized users.
To lock the controller:
1.While the power is on, press and hold the on/off button until it beeps (approximately 2 seconds).
2.Release the on/off button.
3.Move the joystick to the full forward position until it beeps.
4.Move the joystick to the full rearward position until it beeps.
5.Release the joystick. There will be one long beep. The controller system is now locked.
32 | www.pridemobility.com | Jet 3 Ultra |
