V I I I . C A R E A N D M A I N T E N A N C E
Disposal of Your Power Chair
Your power chair must be disposed of according to applicable local and national statutory regulations. Contact your local waste disposal agency or authorized Pride Provider for information on proper disposal of power chair packaging, metal frame components, plastic components, electronics, and batteries.
Cleaning and Disinfection
!Use a damp cloth and mild,
!If necessary, clean your product with an approved disinfectant. Make sure the disinfectant is safe for use on your pro- duct before application.
WARNING! Prevent personal injury and product damage! Follow all safety instructions for the proper use of the disinfectant before applying it to your product.
WARNING! Never hose off your power chair or place it in direct contact with water. Your power chair has a painted, ABS plastic body shroud that allows it to be easily wiped clean with a damp cloth.
WARNING! Never use any chemicals to clean a vinyl seat, as they may cause the seat to become slippery or dry out and crack. Use soapy water and dry the seat thoroughly.
Wheel Replacement
If you have pneumatic tires and you have a flat tire, you can replace the tube. If your chair is equipped with a solid tire insert, then you must replace the whole wheel assembly. Replacement tires, tubes, and wheel assemblies are readily available through your authorized Pride Provider.
WARNING! To avoid possible injury, be sure that the controller’s power is turned off and the power chair is not in freewheel mode before performing this procedure.
WARNING! Completely deflate the tire before attempting repair.
| AXLE KEY |
| AXLE SLOT |
DRIVEWHEEL | DRIVEWHEEL |
NUT | WASHER |
Figure 24. Jet 3 Ultra Drive
| TIRE | WHEELHUB |
|
| |
| TUBE |
|
FRONT RIM |
|
|
HALF |
| REAR RIM |
|
| HALF |
NUTS |
|
|
| WASHERS |
|
Figure 25. Jet 3 Ultra Drive Wheel Disassembled
36 | www.pridemobility.com | Jet 3 Ultra |