V I I I . C O M F O R T A D J U S T M E N T S

ARMREST WIDTH ADJUSTMENT

The Legend armrest width can be adjusted inward or outward.

1.Loosen the armrest adjustment knobs at the back of the seat frame. See figures 13 and 14.

2.Slide the armrests in or out to the desired width.

3.Tighten the armrest adjustment knobs as required.

The armrests can also be lifted upward to allow getting on and off of your Legend easier.

ARMREST HEIGHT ADJUSTMENT

Refer to figure 14 when adjusting the armrest height.

You will need the following tools to adjust the height of the armrests:

5/32-in. hex key •1/8-in. hex key • 7/16-in. wrench

1.Loosen the setscrew on the side of the height adjustment tube with the 1/8-in. hex key.

2.Loosen and remove the acorn nut and screw holding the height adjustment tube in place.

3.Raise or lower the height adjustment tube to the desired height.

4.Align the holes in the adjustment tube with the holes in the armrest upright.

5.Insert the screw through the holes in both the height adjustment tube and the armrest upright.

6.Install and tighten the acorn nut.

7.Tighten the setscrew on the side of the height adjustment tube.

8.Repeat for the other armrest.

ARMREST

HEIGHT ADJUSTMENT TUBE

SETSCREW

ACORN NUT

ARMREST UPRIGHT

ARMREST ADJUSTMENT KNOB

FIGURE 14. ARMREST ADJUSTMENTS

Legend

31

Page 31
Image 31
Pride Mobility SC300, SC340 owner manual Armrest Width Adjustment, Armrest Height Adjustment