Pride Mobility Victory 9 PS, Victory 10 manual How do I change a battery in my scooter?

I V . B A T T E R I E S A N D C H A R G I N G

How do I change a battery in my scooter?

Your scooter requires two 12-volt, deep cycle, U-1 (31-36 Ah) batteries that are sealed and maintenance free. Only sealed, non-spillable batteries that meet DOT CRF 173.459 should be used with your scooter. Replacement batteries should be obtained from your authorized Pride Provider to ensure proper conform- ability, fit, and function.

MANDATORY! Battery posts, terminals, and related accessories contain lead and lead compounds. Wear goggles and gloves when handling batteries and wash hands after handling.

WARNING! Always use two batteries of the exact same type, chemistry, and amp- hour (Ah) capacity. Refer to the specifications table in this manual and in the manual supplied with the battery charger for recommended type and capacities.

WARNING! Do not mix old and new batteries. Always replace both batteries at the same time.

WARNING! Contact your authorized Pride Provider if you have any questions regarding the batteries in your scooter.

WARNING! Do not replace the batteries while the scooter is occupied.

WARNING! The batteries on your scooter should only be serviced or replaced by an authorized Pride Provider or a qualified technician.

To change the batteries in your scooter:

1.Remove the seat and battery shroud.

2.Disconnect the battery tie-down strap.

3.Disconnect the battery harnesses by pulling them straight up. See figure 11.

4.Disconnect the battery cables from the battery terminals by sliding back the terminal boots and unscrewing the nut from the bolt. See figure 13.

5.Remove the old batteries from the battery wells.

6.Place a new battery in each battery well. Face the battery terminals of each battery away from the seat post. See figure 12.

7.Connect the red battery cable to the positive (+) battery terminal on each battery.

8.Connect the black battery cable to the negative (-) battery terminal on each battery.

9.Reposition the terminal boots over the battery terminals.

10.Reconnect the battery harnesses.

11.Reconnect the battery tie-down strap.

12.Reinstall the battery shroud and seat.

NOTE: If you encounter a damaged or cracked battery, immediately enclose it in a plastic bag. Contact your local waste disposal agency or your authorized Pride Provider for instructions on disposal and battery recycling, which is our recommended course of action.

Victory Series www.pridemobility.com 27