V I . C O M F O R T A D J U S T M E N T S
TILLER ANGLE ADJUSTMENT
WARNING! Remove the key from the key switch before adjusting the tiller or the seat. Never attempt to adjust the tiller or the seat while the scooter is in motion.
Your scooter is equipped with an adjustable pivoting tiller.
1.While supporting the tiller, turn the tiller adjust- ment knob counterclockwise to loosen the tiller. See figure 14.
2.Move the tiller to a comfortable position.
3.Turn the tiller adjustment knob clockwise to secure the tiller in position.
NOTE: In order to fully lower the tiller for purposes of disassembly or transport, you must first completely remove the seat. See VII. “Disassembly and Assembly.”
MIRROR POSITION
To install the mirror (see figure 15):
1.Determine on which side to install the mirror and remove the rubber plug from the top of the tiller handle.
2.Insert the threaded end of the mirror holder into the opening and rotate it clockwise until snug.
3.If necessary, rotate the nut clockwise to secure the mirror in place.
To adjust the mirror:
1.Position yourself in a seated driving position fac- ing forward.
2.Adjust the mirror left, right, up, or down until you have a good line of sight behind you.
ARMREST WIDTH ADJUSTMENT
The armrest width can be adjusted inward or outward.
1.Loosen the armrest adjustment knobs. See figure 16.
2.Use the attached ring to pull and remove the detent pins.
3.Slide the armrests in or out to the desired width.
4.Align the adjustment holes on the seat frame and armrest, then reinsert the detent pin.
5.Tighten the armrest adjustment knobs.
NOTE: Pivot the armrests upward to aid in getting onto and off of your scooter.
TILLER |
ADJUSTMENT |
KNOB |
Figure 14. Tiller Adjustment
MIRROR HOLDER
RUBBER PLUG
NUT
Figure 15. Mirror Installation and Positioning
DETENT PINS |
ARMREST |
ADJUSTMENT |
KNOBS |
Figure 16. Armrest Width Adjustment
32 | www.pridemobility.com | Victory Series |
