Pride Mobility Victory 9 PS manual I I . B a S I C Troubleshooting, Diagnostic Fault Codes

V I I I . B A S I C T R O U B L E S H O O T I N G

Any electromechanical device occasionally requires some troubleshooting. However, most of the prob- lems that may arise can usually be solved with a bit of thought and common sense. Many of these problems occur because the batteries are not fully charged or because the batteries are worn down and can no longer hold a charge.

DIAGNOSTIC FAULT CODES

The diagnostic fault codes for your scooter are designed to help you perform basic troubleshooting quickly and easily. The scooter will either display a diagnostic flash code or emit a beep code in the event one of the conditions listed below develops.

NOTE: Your scooter will not run unless the fault code condition is resolved and the scooter has been turned off, then turned back on.

FAULT CODE	CONDITION	SOLUTION
(1)	Battery charge is low.	Charge batteries as soon as possible.
(2)	Battery charge is too low.	Charge batteries.
(3)	The scooter's battery voltage is too	Unplug charger and/or turn key off,
	high to operate the scooter, or the	then back on again.
	charger is still connected to the off-
	board charger port.
(4)	Current limit time out.	Turn the scooter off for a few min-
		utes, then turn your scooter back on.
(5)	The manual freewheel lever is in the	Remove the key from the key
	(forward) freewheel position.	switch, then push the manual free-
		wheel lever to the drive (rearward)
		position and restart your scooter.
(6)	Throttle control lever not at center	Return the throttle control lever to
	position at start up.	center position, turn scooter off then
		back on.
(7)	Speed pot error.	Call your authorized Pride Provider
		for assistance.
(8)	Motor volts error.	Call your authorized Pride Provider
		for assistance.
(9)	Other internal errors.	Call your authorized Pride Provider
		for assistance.

What if all the systems on my scooter seem to be dead? Make certain that the key is in the “on” position. Check that the batteries are fully charged.

Push in the main circuit breaker reset button. See III. “Your Scooter.”

Make certain that both battery harnesses and the front-to-rear harness are firmly connected. See VII. “Disassembly and Assembly.”

Be sure the power down timer feature has not been activated. See V. “Operation.”

Victory Series www.pridemobility.com 37