JVC UX-F70MD manual Troubleshooting, 65, English, Signification, Solution, Symptom, Possible Cause

English

Message	Signification
SCMS CANNOT	Digital copy of the 2nd generation is
COPY	prohibited.

Solution

Use the external equipment connected to the LINE IN jacks (as the recording/ playback device.)

TRACK

PROTECTED

X4 SPEED

CANNOT COPY

LOW TEMP

The track has been protected.	This unit can not unprotect it.
	To unprotect it, use the equipment with
	which it was protected.
The room temperature is too low to	This is not a malfunction. You can
record using x4 speed-recording.	record using x4 speed-recording within
	5˚C – 35˚C.

CANNOT PLAY

CD LOAD ERROR

UNFINALIZE

You are trying to play back a CD which cannot be played or there is a problem with the CD.

The CD tray does not open correctly because of the obstruction.

You are trying to play back a CD-R/ RW which has not been ‘finalized’ yet.

Change the CD.

Press CD open/close 0to close the CD tray, then remove the obstruction.

This is not a malfunction. You can play back the ‘finalized’ CD-R/RW.

Troubleshooting

If you are having a problem with your unit, check this list for a possible solution before calling for service.

If you cannot solve the problem from the hints given here, or the unit has been physically damaged, call a qualified person, such as your dealer, for service.

Symptom

No sound is heard.

Unable to operate the remote control.

Unable to record on an MD.

Poor radio reception.

Loaded CD and MD can not be ejected.

The CD does not play.

The disc skips.

The cassette holder does not open or close.

Impossible to record on a tape.

Operations are disabled.

Possible Cause	Action
Connections are incorrect or loose.	Check all connections and make
	corrections. (See pages 6 – 9.)

•The path between the remote control and the • Remove the obstruction. remote sensor on the unit is blocked.

• The batteries have lost their charge.	• Replace the batteries. (See page 9.)
• You are using the remote control far from	• Signals cannot reach the remote
the unit.	sensor. Move close to the unit.
• You are using a prerecorded MD.	• Use a recordable MD.
• The MD is write-protected.	• Unprotect the MD. (See page 30.)
• The antenna is not connected correctly.	• Reconnect the antenna securely.
• The AM loop antenna is too close to the	• Change the position and direction
unit.	of the AM loop antenna.
• The FM antenna is not properly extended	• Extend FM antenna to the best
and positioned.	reception position.
The main AC power cord is not plugged in.	Plug it in the AC power plug.
The CD is upside down.	Put the CD in with the label side up.
The disc is dirty or scratched.	Clean or replace the disc. (See page 61.)
Power supply from the AC power cord has	Turn on the unit.
been cut off while the tape was running.
Small tabs on the back of the cassette are	Cover the holes with adhesive tape.
removed.
The built-in microprocessor has malfunctioned	Unplug the unit then plug it back in.
due to external electrical interference.

– 65 –