Continued
English
To connect speakers
You can connect the speakers by following the procedure
below. |
|
|
| |
1 |
|
|
| |
2 | Speaker terminals | 3,4 | ||
| SPEAKER IMPEDANCE | Red | ||
|
| MIN 4Ω |
| |
Speaker cord | + | + | Speaker cord | |
R | L | |||
| ||||
|
| |||
| – | – |
| |
|
| Black |
| |
| R |
| L | |
Rear of the right | Rear of the left | |||
speaker |
| speaker |
1If cords are covered with insulation, twist the core of the cord at the end of each cord, then remove the insulation.
2Open the speaker terminal.
3Insert the end of the speaker cord to the terminal. Match the polarity: White cord to red (+) terminal and black cord to black
4Close the speaker terminal on the rear of the unit.
Use only speakers with the speaker impedance — 4 Ω to
16Ω.
Connecting Other Equipment
You can connect the following equipment which can be used as a playback device.
When you connect and use the equipment, refer also to its manual supplied.
• DO NOT connect other equipment while the power is on.
•DO NOT plug in any equipment until all connections are complete.
To connect another component such as analog audio equipment
Be sure that the plugs of the audio cords and the jacks on the rear of the unit are
| LINE IN |
| (AUX) |
R | L |
SPEAKER IMPEDANCE | |
MIN 4 | |
R | L |
AC IN |
|
Ex. Analog audio |
|
equipment |
|
| To output |
For playing the other equipment through this unit,
connect between the audio output jacks on the other equipment and LINE IN (AUX) jacks by using audio cords (not supplied.)