Continued
English
Adjusting the Volume
You can adjust the volume level only while the unit is turned on. The volume level has no effect on recording.
To increase the volume, press VOLUME + . To decrease the volume, press VOLUME
(Maximum)
(Minimum)
The volume level meter appears on the display.
•The volume level can be adjusted in 41 steps (VOL MIN, VOL 1 – VOL 39, and VOL MAX.)
•When pressing and holding the button, you can change the volume level continuously.
For private listening
Connect a pair of headphones to the PHONES jack. No sound comes out of the speakers. Be sure to turn down the volume before connecting or putting on the headphones.
If “CANNOT LISTEN!” appears on the display
During
DO NOT turn off (on standby) the unit with the volume set to an extremely high level; otherwise, the sudden blast of sound can damage your hearing, speakers and/or headphones when you turn on the unit or start playing any source.
REMEMBER you cannot adjust the volume level while the unit is in standby mode.
Turning On/Off the Key-touch Tone
You can deactivate the
On the remote control ONLY:
Press BEEP.
•Each time you press the button, the
BEEP ON 
BEEP OFF
Reinforcing the Bass Sound
The richness and fullness of the bass sound is clearly maintained regardless of how low you set the volume — Active Hyper Bass Pro. The AHB PRO effect can be applied only to playback sounds, and cannot be used for recording.
On the remote control ONLY:
To get the effect, press AHB PRO.
The AHB PRO indicator lights on the display.
•Each time you press the button, the effect changes as follows:
AHB 1 
AHB 2
AHB OFF
(Canceled)
AHB 1: Bass sound is clearly heard even in the low volume.
AHB 2: More richness and fullness of the bass sound is heard.
AHB OFF: Cancels the AHB PRO effect.
The AHB PRO indicator goes off from the display.
To check the AHB PRO setting currently selected, press AHB PRO once while the AHB PRO indicator is lit.
Selecting the Sound Modes
You can select one of the 4 preset sound modes. The sound modes can be applied only to playback sounds, and cannot be used for recording.
On the remote control ONLY:
To select the sound modes, press SOUND MODE repeatedly until the sound mode you want appears on the display.
The SOUND indicator also lights on the display.
•Each time you press the button, the sound mode changes as follows:
ROCK 
POP 
CLASSIC
FLAT 
JAZZ 
(Canceled)
ROCK: Boosts low and high frequency. Good for acoustic music.
POP: Good for vocal music or voice.
CLASSIC: Good for classical music.
JAZZ: Good for jazz music.
FLAT: Cancels the sound mode.
The SOUND indicator goes off from the display.
To check the sound mode currently selected, press SOUND MODE once while the SOUND indicator is lit.
– 12 –
