English
3)Repeat steps 5
•If the character you want to input next is assigned to the same button you have just pressed in step
5
•The main display can only show 15 characters at a time. If you enter the 16th character, the first character disappears from the display, and so on.
6 Press ENTER to finish the current title entry.
After “EDITING” appears on the display for a while, the unit enters the next title entry mode (if any.)
•You can assign another title by repeating steps 3 to 6.
7 Press MD open/close 0on the main unit to eject the
MD.
“UTOCwriting” appears on the display while the editing you have made is being recorded on the MD.
You can assign titles during play or recording
•During play: Entering a disc title
The MD recorder repeats playback of all tracks of the MD until you press ENTER in step 6 above. When you press ENTER, the MD recorder enters the track title entry mode.
Entering a track title
The MD recorder repeats playback of the current track until you press ENTER in step 6 above. When you press ENTER, the MD recorder enters the next track title entry mode.
Entering a group title
The MD recorder repeats playback of all the tracks of the current group until you press ENTER in step 6 above. When you press ENTER, the MD recorder enters the next group title entry mode.
•During recording:
Entering a disc title, track title and group title
The MD recorder continues recording even after you press ENTER in step 6 above. When you press ENTER, a title is assigned to the track or group where you have started the title entry. If you do not press ENTER before recording ends, the title assigned will be canceled. (When assigning titles to a disc or track, next title entry mode appears.)
You cannot assign group title if the MD has no group or “GROUP OFF” is selected.
•During CD Synchronized Recording (see page 32):
You can assign the disc title, and 16 track titles one after another as recording goes on. The track titles you have entered are automatically assigned to the tracks recorded on the MD in sequential order.
Available Symbols are as follows:
(Blank) |
Changing the Title
You can make a correction or change the title.
1 Follow steps 1 to 4 on page 54.
2 Press = or +to select the character you want to correct.
•Make sure that the character you want to change is flashing.
3 Press CANCEL to delete the character you have selected in the above step.
4 Input the correct character, referring to step 5 on page 54 and this page.
5 Repeat steps 2 to 4 of the current procedure to correct more characters.
6 Press ENTER to finish correcting the title.
•If you want to correct another title, select another title entry mode by pressing =or +, press SET, and then repeat from step 2 above.
•If you want to finish the correction, go to the next step.
7 Press MD open/close 0 on the main unit to eject the
MD.
“UTOCwriting” appears on the display while the editing you have made is being recorded on the MD.
To erase all the characters
Press CANCEL repeatedly in step 3 above to erase all the characters, then go to step 6 and 7.
