English
Setting the AM Tuner Interval Spacing
Some countries space AM stations 9 kHz apart, and some countries use 10 kHz spacing.
When shipped, the
On the main unit ONLY:
To set the AM tuner to the 10 kHz spacing, be sure that the unit is turned off, but is plugged into a wall outlet.
While holding ¢, press 
STANDBY/ON. The unit turns on and “AM 10 kHz” appears on the display for a while.
To set it back to the 9 kHz spacing, be sure that the unit is turned off, but is plugged into a wall outlet.
While holding 4, press 
STANDBY/ON. The unit turns on and “AM 9 kHz” appears on the display for a while.
Tuning in a Station
1 Press FM/AM/AUX (or FM/AM on the main unit) repeatedly to select “FM” or “AM.”
The unit automatically turns on with the last source selected.
•Each time you press the button, the source changes as follows:
When using the | When using the |
remote control: | main unit: |
FM |
|
| AM |
| |
|
| ||||
(TUNER) | FM |
| AM | ||
| |||||
AUX | (TUNER) |
| |||
|
|
| |||
2 Press and hold ¢or 4until the station |
| ||||
frequencies start changing continuously on the display.
•¢: to increase the frequencies.
•4: to decrease the frequencies.
The unit starts searching stations and stops when a station of sufficient signal strength is tuned in.
Ex. An FM station is tuned in.
•If an FM program is broadcast in stereo, the ST (stereo) indicator lights on the display.
To stop during searching, press ¢or 4.
When you repeatedly press ¢or 4
The frequency changes step by step.
To change the FM reception mode
When an FM stereo broadcast is noisy or hard to receive, you can change the FM reception mode to improve the reception.
On the remote control ONLY:
Press FM MODE so that the MONO indicator lights on the display.
•Each time you press the button, MONO indicator lights and goes off alternately.
When the MONO indicator is lit:
Reception improves though stereo effect is lost.
When the MONO indicator is not lit:
You can hear stereo sound when a program is broadcast in stereo.
The ST indicator lights while receiving the FM stereo broadcast.
In addition, static noise between stations will be erased while tuning.
Presetting Stations
You can preset 30 FM and 15 AM stations manually.
In some cases, test frequencies have been already memorized for the tuner since the factory examined the tuner preset function before shipment. This is not a malfunction. You can preset the stations you want into memory by following the presetting method.
•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 2 again.
On the remote control ONLY:
1 Tune in a station you want to preset.
• See “Tuning in a Station” to the left.
2 Press SET.
The preset number starts flashing as follows:
•When you select an FM station in step 1
•When you select an AM station in step 1
Preset No. 1 alway appears at first.
