IMPORTANT:
Due to the wide variety of media you may need to adjust the heat setting of your laminator to get the best transfer. If the laminate is not fully transferring to the disc, the heat must be increased. However, if the heat is set too high, the printed image on the disc may be distorted. Excessive heat may even cause the label side to peel off of the disc. Because of this you should use the least amount of heat necessary to transfer the laminate film to the surface of your disc.
TM
DISC PUBLISHER
AutomatedCD/DVDOpticalOpticalDisc
4Adjusting the Center Hub
1.If the laminate is not adhering to the hub in the same manner as the rest of the disc, you may wish to avoid laminating the center hub. To do this, lift the Tray Disc Hub Spacer from the center of the Disc Tray and rotate it slightly clockwise. Place it back into the center of the Disc Tray making certain it seats properly in the tray.
Disc Hub Spacer
Disc Surface
| Disc Present | |
| Sensor | |
With the Disc Tray Hub in this |
| |
position, laminate will be | Hub is even with | |
transferred to the hub of the | ||
disc surface | ||
disc. | ||
| ||
| Disc Surface | |
| Sensor |
2.Repeat the test with another disc. When you are satisfied with the setting, you may want to make a note of them for future reference. You are now ready to laminate your discs.
DuplicationDisc Laminator& Printing System
Quick Start
With the Disc Tray Hub in | Hub is | |
this position, laminate will | ||
recessed to | ||
NOT be transferred to the | ||
disc surface | ||
hub of the disc. | ||
Disc Surface | ||
| ||
| Sensor |
P/N
♥2005 All rights reserved.
