Printek MtP300 Series Interface Menu

Printer Configuration

Interface Menu

INTERFACE MENU

After entering Setup as described earlier in “Setup Basics”, press the Advance Button until “INTERFACE

MENU” is displayed on the top line.

The bottom line displays the currently selected host interface. The Interface Menu provides access to the

features that may be configured for the currently selected interface.

Note that the Serial interface is standard in all MtP300 Series printers. If another, optional interface such as

IrDA, Bluetooth, or Wi-Fi is installed, you may select between the Serial interface and the optional interface by

pressing the Arrow Button. Once the desired interface is displayed, you may do one of the following:

press the Enter Button to review and/or change the features related to the selected interface, or

press the Advance Button to advance to the OPTIONS MENU

Pressing the Enter Button will advance through the following features for the selected Interface in the order

listed below.

Please refer to “Interfacing To A Host Computer” on page 33 for additional information.

INTERFACE MENU

Serial

Note that “Serial” must be displayed on the bottom line of the display in order to access the following

features and for this interface to be active when Setup is exited.

Emulation Emulation

Printek

Possible Values: Printek*, O’Neil, ZPL-II, Mt3, CPCL, Hex Dump

This feature sets the family of printer commands that may be used by a host application program to control the

various capabilities of the printer. The printer will only respond to commands valid for the currently selected

emulation. For more information, please refer to the MtP Series & FieldPro Programmer’s Manual.