SERVICE INDICATIONS:
A hazardous condition may result if a heater has been modified or is not functioning properly. When the heater is working properly:
1.The flame is contained within the heater.
2.The flame is essentially yellow.
3.There is no strong disagreeable odor, eye burning or other physical discomfort.
4.No smoke or soot exists internal or external to the heater.
5.No unplanned or unexplained shut down of the heater occur.
REPLACEMENT
REPLACEMENT PARTS:
Note: Use only original replacement parts. This will protect your warranty coverage for parts replaced under warranty.
PARTS UNDER WARRANTY:
Contact authorized dealers of this product. If they can't supply original replacement part(s) call
When calling
Your name Your address
Model and serial numbers of your heater How heater was malfunctioning
Type of gas used (propane/LP or natural gas)
Usually, we will ask you to return the defective part to the factory.
PARTS NOT UNDER WARRANTY:
Contact authorized dealers of this product or Parts Central if they can't supply original replacement part(s) Call
When calling
Model number of your heater
The replacement part number
ACCESSORIES
Purchase these heater accessories from your local dealer or Parts Central. If they cannot supply these accessories call
SPECIFICATIONS
Btu |
| 50000 |
Gas Type |
| LP Gas Only |
Ignition |
| Piezo |
Inlet Gas Pressure* (In. of water) | ||
Maximum |
| 13” |
Minimum |
| 11” |
Dimensions, Inches (HxWxD) | ||
Stove | 42 9/16”x26”x26” | |
Carton | 30 5/16”x27 3/4”x27 3/4” | |
Weight, Lbs |
|
|
Stove |
| 141 |
Shipping Weight | 163 | |
* For purpose of shipment adjustment.
TROUBLESHOOTING
OBSERVED PROBLEM
Burner does not light.
When ignitor buttons pressed in, there is no spark at safety Pilot.
Burner fire does not last.
POSSIBLE CAUSE
1.Air in gas lines.
2.Inlet gas pressure is too low.
3.Gas supply turned off.
4.Air passageway on heater blocked.
5.Burner orifice clogged.
6.Control knob not in ING/ON position.
7.Control knob not fully pressed in while in ING/ON position.
1.Ignitor electrode positioned wrong.
2.Ignitor electrode broken.
3.Broken ignitor cable.
4.Ignitor electrode not connected to ignitor cable.
1.Damaged thermocouple.
2.Thermocouple electrode corrosion.
3.Damaged control valve.
4.Control knob not pressed long enough.
5.Thermocouple connection loose at control valve.
6.Pilot flame not touching thermocouple.
8
REMEDY
1.Continue holding down control knob. Repeat igniting operation until air is removed.
2.Check gas pressure.
3.Fully open gas supply.
4.Check air passageway.
5.Clean burner.
6.Turn control knob to ING/ON position.
7.Press down control knob.
1.Reposition ignitor.
2.Replace ignitor.
3.Replace ignitor cable.
4.Connect electrode to ignitor cable.
1.Replace thermocouple.
2.Clean thermocouple electrode.
3.Replace control valve.
4.After ODS/pilot lights, keep control knob pressed in for 30 seconds.
5.Hand tighten connection or replace thermocouple.
6.Contact qualified service man.
