Procom AL500HYLA Product Features, Installation, Burner fixing plate, Place grate on burn plate

PRODUCT FEATURES

SAFETY PILOT

The heater has a pilot with a safety shutoff system. The safety pilot is a required feature for outdoor heaters. It shuts off the heater if flame is extinguished by rough wind.

PIEZO IGNITION SYSTEM

This heater has a piezo igniter. This system requires no matches, batteries, or other sources to light heater.

INSTALLATION

TOOLS REQUIRED:

●Philips screwdriver

●Wrench

Check if you have the items listed below before

installation.
● Logs: 10	● 4×14 self-tapping screw: 5
● M4×10 screw: 32	● M5×10 screw: 4
● Column: 4	● Log grate: 1
● Fixing hoop: 1	● Hex head screw: 2
● Handle: 1	● Screen: 4

Caution: Some of the steel edges may be sharp. Please use caution when assembling the unit.

INSTALLATION INSTRUCTIONS:

1.Remove grate out of base and set flat on floor.

2.Take log foam package out of base. Please note each log fits the number marked on foam package.

3.Unscrew the 16 screws that attach the top panel and the middle base with short columns. Remove top panel and short columns. Then set flat on the floor. (See FIG.3)

Note: Short Columns and Self-tapping Screws are used for packing only.

Figure 3-Burner fixing plate

4.Place grate on burn plate. Make sure to line up the red mark and five holes of grate with that of burn

plate. Then secure grate to burn plate with 5 4× 14 Self-tapping Screws. (See FIG.4)

Figure 4-Place grate on burn plate

3 AL058-01