Bosch Appliances 3922 988 43318 Windows and DCN Software modules, Installing PC-Network card

Digital Congress Network Installation and Operating Manual Chapter 5 - Control using PC

5.2.1 Installing PC-Network card

en 5-3

WARNING: Before connecting a computer to the DCN network cabling, ensure the

following: Refer also to the ‘Safety Precautions’ found at the front of this manual.

1. The mains supply is OFF.

2.The voltage selection switch on the computer is set for the correct mains voltage.

3.Refer to the manual supplied with your PC on how to install a PC-card. Follow the recommended installation procedures.

5.2.2Interconnections PC Network card

Connecting PC to DCN cabling

•For connection via Network card see FIG 5-4.

•For ‘DIRECT’ connection to a PC (no PC-Network card necessary) see Chapter 5.2.

NOTE: The PC when fitted with a PC-Network card LBB 3510/00, as with all other DCN system units, can be connected to any convenient point within the trunk-line cabling. It can also be connected ‘DIRECT’ to a Central Control unit (<15 m) . However, when connecting a PC to the trunk-line cabling no loop-through facility is available.To bypass the PC, a trunk-splitter or Tap-off unit can be used. For more information see Chapter 10..

Connecting Intercom handset

To connect an intercom handset to the PC, locate the Modular jack socket (2) on the PC-Network card LBB 3510/00). and connect the intercom’s modular jack to it.

Connecting Headphones

DCN PC

Mains 1 2

Mouse

Mains

PC-network card

LBB 3510/00 (FIG 5-2)

Trunk-line

To previous unit

3

5

LBB 3555/00

Intercom Handset

For operator monitoring, connect headphones to the 3.5 mm jack socket (1) located on the PC Network card (FIG 5-4).

Headphones

FIG 5-4 Interconnection Personal Computer (PC)

5.3Windows and DCN Software modules

Refer to relevant DCN software manuals.

For available software packages refer to Chapter 1.

Bosch Security Systems 04-2003 3922 988 43318 en Windows and DCN Software modules