Bosch Appliances 3922 988 43318 manual Control PC, Com, ‘wire-to-wire’

Digital Congress Network Installation and Operating Manual Chapter 5 - Control using PC en 5-7

EXAMPLE 1: SINGLE-CCU system with control PC and Camera control

						Control PC with
	9-pole D-type cable connections					Windows 95, 98, NT 4.0 or 2000
IMPORTANT: The LBB 3510/00 PC							NOTE: The number of required PC COM-
					Control PC
Network card CANNOT be used in a PC		CCU LBB 3500/15	PC				ports depend on the number of permanent
running Windows NT 4.0 or 2000.							connections for peripheral devices (e.g. ID
		DCD 1		1 DCD			chip-card encoder, and serial printer).

Simultaneous use of the PC-Network card		RD 2		2	RD
and ‘DIRECT’ connection is NOT possible.		TD 3		3	TD	COM 2*	COM 1	* The COM-port for CCU control is selected
		DTR 4		4	DTR
								during DCN software installation. COM 2 is
NOTES:		GND 5		5	GND
		DSR 6		6	DSR			default when no ID chip card-encoder is used
1. When using the ‘DIRECT’ method the		RTS 7		7	RTS			(COM 3 is recommended otherwise).
	functions of the PC-Network card are	CTS 8		8	CTS	RS232	RS232
		RI 9		9	RI
	NOT available (i.e. headphones and
		Male	‘wire-to-wire’	Female		Male	Male
	intercom). These functions are available
	on the DCN Concentus units or with the
	‘Multi-purpose connection unit’ LBB						Serial printer
	3540/15.		‘DIRECT’ DCN PC control
							(default)
2.	The baud-rate setting of the PC COM-		- CCU Port 1
	port and the corresponding CCU Port		- Protocol: FULL
			- Baudrate: 115.2k
	must be the same. If a different setting is
	required this setting must be selected	see Note 2
	accordingly:

CCU: DIP-switch S14 on TCB4.

PC: During DCN software installation	LBB 3500/15
or in the dcn.ini file

CAMERA control with Allegiant	Port 1	Rec.	Line	Trunk
video switcher		In	In
	Port 2
- CCU Port 2		Out	Out	115 V -T4A 230 V -T2A
- Protocol: CAMERA			Symmetrical
- Baudrate: 19.2k

Allegiant video switcher		DCN Trunk-lines
		(see also Chapter 10.7)
	ALLEGIANT Video System
	Power	The default functions of Port 1 and Port 2 can be interchanged or set for use with remote
	Status
	Code Out
	Alarm	control devices or for ‘Test/Diagnostic’ purposes instead of camera control by DIP-switch
	Battery Low
		(S14) on the TCB4 card (see Chapter 4.5 and Chapter 4.6).
See Chapter 6.. for installation details

FIG 5-6 Example SINGLE-CCU system with control PC and Camera control

Bosch Security Systems 04-2003 3922 988 43318 en Connection PC to CCU