Bosch Appliances 3922 988 43318 manual Menu k. Select auto-relay booth, End Programming session

Digital Congress Network Installation and Operating Manual Chapter 11 - System Set-up and Operation en 11-27

Menu k. Select auto-relay booth

This function is only available if in Menu J,‘Select number of auto-relay booth(s)’ is set to either

[1, 2 or 3], if [ NONE] was selected, this menu is bypassed.The number of booths available for selection is dependent on the number of booths installed.The selection made is set for all interpreter desks installed in that booth.The following screen shows the selection for booth 1 only. If in Menu J, 2 or 3 booths have been selected, use the B-select key to select the remaining number of booths.

Menu l. Select microphone locks between booths

Using this menu ‘Select microphone locks between booths’ enables an ‘Override’ and ‘Interlock’ facility to be assigned between booths.The ‘Override’ function allows an interpreter to override another interpreter in a different booth supplying the same interpretation channel.The ‘Interlock’ function, blocks another interpreter from using the same channel in a different booth.

The function set is for all interpreter desks installed in the system.

Procedure:

Select Menu j, ‘Select auto-relay booth n’ as described in step 2 (Programming procedures). The following Menu is displayed:

Select auto-relay booth 1:

<Booth 1> k

abc

A B

Engaged

1.Rotate the ‘Relay select’ knob to scroll and select the booth number as described in Programming procedures Step 3.

2.Press the ‘Floor’ key to enter the required choice. Refer to step 4 or repeat the above steps for the next booth.

Procedure:

Select Menu l, ‘Select microphone locks between booths’ as described in step 2 (Programming procedures).The following Menu is displayed:

Select microphone locks between booths:

<NONE> OVERRIDE INTERLOCK l

abc

A B

Engaged

1.Rotate the ‘Relay select’ knob to scroll and select NONE, OVERRIDE or INTERLOCK as described in Programming procedures Step 3.

2.Press the ‘Floor’ key to enter the required choice. Refer to step 4.

End Programming session

To end the programming session and enter the desk in to its normal operational mode press the key ‘Relay select b’ and the ‘B’ key simultaneously.

End, use keys ‘b’ and ‘B’ to return to

operational mode

a b c

A B

Engaged

Bosch Security Systems 04-2003 3922 988 43318 en Programming the Interpreter desk