INSTALLATION
This product has been certified as commercial cooking equipment and must be installed by professional personal as specified.. THIS APPLIANCE IS NOT RECOMMENDED FOR RESIDENTIAL INSTALLATION..
We suggest installation, maintenance and repairs should be preformed by your local Garland/US Range authorized service agency..
Siting
The floor on which the appliance is to be sited must be capable of adequately supporting the weight of the appliance and any ancillary equipment.. Units with ovens must be fitted with legs if installed on a combustible floor.. Adequate clearance must be provided for servicing and proper operation..
Appliances Equipped With Casters
1. The installation shall be made with a connector that |
complies with the Standard for Connectors for Moveable |
Gas Appliances, ANSI Z21..69/CSA 6..16, Addenda Z21..69B- |
2006/CSA |
disconnect device that complies with the Standard for |
Quick Disconnects for Use with Gas Fuel, ANSI Z21..41/ |
3.Once legs have been attached and secured they can be adjusted to level the appliance and compensate for uneven flooring..
Installing Shelf To Backguard
Note: Shelf may be installed before or after installing the backguard to the range..
1.Loosen 4 bolts on the front of the backguard approximately 1/4” (6mm)..
2.Align the 4 slotted holes on the back of the shelf with the 4 bolts on the backguard..
3.Slide the shelf downward until the 4 bolts are engaged in the slotted portion of the keyhole..
4.Tighten the 4 bolts to secure the shelf..
5.On 60” units only, install a sheet metal screw though the hole in the underside of the shelf into the backguard and tighten..
| CSA 6..9, Addenda |
| latest edition).. |
2. | The front casters of the appliance are equipped with |
| brakes to limit the movement of the appliance without |
| placing any strain on the connector or quick disconnect |
| device or its associated piping.. |
3. | Please be aware; required restraint is attached to a |
| bracket, (which is located on the rear of the caster closest |
| to the gas connection), and if disconnection of the |
MOUNTING BOLTS
BACKGUARD
SHELF |
SHEETMETAL |
SCREW |
restraint is necessary, be sure to reconnect the device |
after the appliance has been returned to its original |
position.. |
Appliances Equipped With Legs
1.Raise the front of the appliance and block.. Do not lay the appliance on its back..
2.Legs are threaded to be easily screwed into the holes provided on the bottom of the range..
Backguard With High Shelf, Salamander Or Cheesemelters Mounting Instructions
1.Rear of the range must be easily accessible..
2.Place the backguard, high shelf, salamander, or cheesmelter on the rear of the range, slipping the support brackets into the openings in the main body sides..
Page | Part # 4523343 Rev 1 (02/12/08) |