Sunfire X Series Operation, Open Top burners, Ovens Standard, Hot Top Sections, Lighting

OPERATION

Open Top burners

Lighting

1.Light pilots adjacent to each burner..

2.Turn valve completely on.. Burner flame should be 1/2” (13mm) high, stable and blue in color.. It should also impinge on the bottom of a pot placed on the burner grate..

CAUTION: Should burner ignition fail within 4 seconds, turn the burner valve off and repeat steps 1 through 2.. If ignition continues to fail, consult your factory authorized service agency..

Ovens (Standard)

Lighting

1.Lower front kick panel below oven door, raise oven hearth bottom for easy access to oven pilot..

2. Turn oven control knob (figure 1) to “ ” position and then push in to engage the flow of gas through the safety device to the pilot..

Figure 1

3.While holding knob in, light pilot with a match/BBQ lighter or use the spark ignition (if provided) to spark ignite pilot..

4.Continue to hold knob in for 15 seconds after ignition, then release.. Pilot should remain lit..

5.If pilot burner fails to light or does not stay lit, wait 5 minutes and repeat steps 2 through 4..

6.Replace hearth and close kick panel, then turn oven thermostat to desired cooking temperature..

7.To shut down main burner turn control knob (figure 1) to “ ” position..

Shut Down

If pilot shut is down is required remove the temperature thermostat knob by pulling it off carefully, then turn the inner control knob (figure 2) to position.. The system will disengage with 60 seconds..

Figure 2

Hot Top Sections

1.Raise or remove hot top plate section(s).. Each burner has one pilot located at the front left side of the burner..

2.Light pilots.. The pilot burner should be adjusted to provide for rapid ignition of the burner..

3.Turn the burner valve on.. A sharp blue flame should be approximately 1/4-inch, (6mm), high..

4.Replace hot top sections..

Valve Controlled Griddles

See griddle seasoning before use..

1.Pilots should be lit though the front panel with an extend match.. If necessary the front panel of the range can be removed to allow the griddle plates to be raised at the front, block securely..

2.Light pilots located at the front right side of each burner..

3.Turn burner valves completely on.. Burners should have 1/2-inch to 5/8-inch, (13mm to 16mm), stable blue flame..

4.If the griddle has been raised, lower carefully into position and replace the front panel of the range..

Part # 4523343 Rev 1 (02/12/08) Page