Proctor-Silex Troubleshooting Guide, Replacement Parts for Model HBH450, Maintenance

			Caring for the Blender
Troubleshooting Guide
Problem . . .		Solution . . .
Blender fails to start		• Check to see if unit is securely plugged into an electric outlet.
or stops while it is		• Check to see if the integrated circuit breaker has tripped and reset it, if needed.
running and cannot		• Check to see if the fuse for the electric outlet has blown or if a circuit breaker
be restarted
		has tripped.
Ingredients will not mix		• Check to see if enough liquid has been added to the ingredients. Mixture should
properly		be fluid and free-running at all times.
		• Solid pieces are too large. Pieces should not exceed 1" cubes.
		• Container is too full. Do not fill past highest graduation marking.
		• Cutter unit blades are not sharp or are damaged. Inspect container and cutter
		assembly daily. Replace cutter assembly at least every 90 days or sooner if cutter
		assembly appears worn or damaged.
		• Check to see if cutter assembly is installed properly.
		• Select speed to create a fluid blend.
Maintenance
Inspect the blender and its various parts and replace as follows:
Daily	Unplug the blender and remove the container from the base, and then inspect the
	container and cutter unit assembly for wear, nicks, and broken or loose blades. Replace if
	necessary. If the blades are loose, discontinue use immediately and replace the blades.
	Do not attempt to repair or tighten the cutter assembly. See “Replacement Parts” below.
Weekly	Unplug the blender, and then inspect the power cord insulation and power plug for cracks.
	Refer to “Technical Service” for repair or replacement.
Quarterly	Replace the container and cutter assembly at least every 90 days. See “Replacement
	Parts” below.
Replacement Parts for Model HBH450
For replacement parts, call toll free: 866-285-1087.
Part Description			Part Number
48 oz. polycarbonate container			6126-450
Cutter assembly			98450

9