ProForm 1800 user manual Assembly, Make sure that the power cord is unplugged

ASSEMBLY

•To hire a service technician to assemble this product in your home, call 1-800-445-2480.

•Assembly requires two persons.

•Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until you finish all assembly steps.

•After shipping, there may be an oily substance on the exterior of the treadmill or on the shipping carton. This is normal. If there is an oily sub- stance on the treadmill, wipe it off with a soft cloth and a mild, non-abrasive cleaner.

•To identify small parts, see page 6.

•Assembly requires the following tools:

the included hex keys one adjustable wrench one Phillips screwdriver a pair of scissors

To avoid damaging parts, do not use power tools.

1. Make sure that the power cord is unplugged.	1
Place a piece of cardboard below the rear of the
Frame (56) to protect the floor or carpet.
Attach the Left Wheel Cap (96) to the Base (94)
with two #8 x 3/4" Screws (2).		56
Attach the Right Wheel Cap (not shown) to
the right side of the Base (94) in the same
way.	94
	2
		96
		Cardboard
2. Pull the Upright Wire (81) and the base ground	2
wire (A) through the indicated hole in the
Base (94).
Attach the base ground wire (A) to the Base (94)
with a #8 x 1/2" Ground Screw (10).	Hole
	81
	10	A
		94
	7