8.With the help of a second person, hold the con- sole assembly near the Right Handrail (64).
Connect the Upright Wire (63) to the console wire. See the inset drawing. The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. IF YOU DO NOT CONNECT THE CON-
NECTORS PROPERLY, THE CONSOLE MAY BECOME DAMAGED WHEN YOU TURN ON THE POWER. Then, remove the wire tie from the Upright Wire.
Connect the Console Ground Wire (47) on the Console Crossbar (61) to the ground wire on the console.
9.Insert the wires into the Right Handrail (64) through the indicated hole as you set the con- sole assembly on the Left and Right Handrails (59, 64). Make sure that no wires are pinched.
Attach the console assembly with four #8 x 3/4" Screws (4). Start all four Screws, and then tighten them. Do not overtighten the Screws.
See assembly step 5. Firmly tighten the six 3/8" x 3 1/4" Screws (2) on the lower ends of the Left and Right Uprights (66, 76) (only one side is shown).
8 | Console |
|
|
|
| Assembly |
|
|
|
| Console |
|
|
|
| Wire |
|
|
|
| 63 | Ground | 47 | |
|
| Wire | ||
| 64 |
|
| |
|
| Console | ||
|
| 61 | ||
|
| Wire |
| |
|
| Wire | 63 |
|
|
| Tie |
|
|
9 |
| Console Assembly |
| |
|
|
| ||
| Ground |
| Wires |
64 |
|
Wires | 59 |
Hole |
|
4 | 4 |
76 | 66 |
|
10
