1. Make sure that the power cord is unplugged. | 1 |
|
|
|
|
|
|
| |
With the help of a second person, carefully tip |
|
|
|
|
the treadmill onto its left side. Partially fold the |
|
|
|
|
Frame (56) so that the treadmill is more stable; |
|
| 38 | Hole |
do not fully fold the Frame yet. |
|
| 83 | |
Cut the tie securing the Upright Wire (38) to the |
| Tie | 81 | |
Base (83). Locate the tie in the indicated hole in |
|
|
|
|
the Base, and use the tie to pull the Upright Wire |
|
|
|
|
out of the hole. |
|
|
| 2 |
Attach a Base Pad (81) to the Base (83) in the |
|
|
|
|
location shown with a Base Pad Spacer (13) and |
|
|
|
|
a #8 x 1" Tek Screw (2). Then, attach another |
| 13 |
|
|
Base Pad (81) with only a #8 x 1" Tek Screw (2). | 56 | 81 |
| |
|
|
| 2 |
|
2. Attach a Wheel (84) with a 3/8" x 2" Shoulder | 2 |
|
|
|
Bolt (111) and a 3/8" Nut (8). Do not over- |
|
|
| |
|
|
|
| |
tighten the Nut; the Wheel must turn freely. |
|
|
|
|
|
|
| 83 |
|
|
| 111 |
|
|
|
| 8 | 84 |
|
|
|
|
| |
3. Identify the Right Upright (78) and the Right | 3 |
|
|
|
Upright Spacer (79), which are marked with |
|
|
| |
38 |
|
|
| |
stickers. Insert the Upright Wire (38) through the |
|
|
| |
|
|
|
| |
Right Upright Spacer as shown. |
|
|
| 78 |
See the inset drawing. Tie the long tie in the |
| Long Tie | 38 | |
Right Upright (78) securely around the end of |
| |||
|
|
| 79 | |
the Upright Wire (38). With the help of a second |
|
|
| |
|
|
| 83 | |
person, hold the Right Upright near the Base |
|
|
| |
(83). Then, pull the other end of the long tie until |
|
|
|
|
the Upright Wire is routed completely through |
|
|
|
|
the Right Upright. |
|
|
|
|
|
| 78 |
|
|
| 38 | Wire |
|
|
|
|
|
| |
|
| Tie |
|
|
| 7 |
|
|
|
