7.Set the console assembly face down on a soft surface to avoid scratching the console assem- bly. Hold the Right Handrail (104) near the con- sole assembly. Next, insert the console wire into the large hole in the Right Handrail and pull it out of the top as shown. If necessary, use needlenose pliers to pull the console wire out. Attach the Right Handrail (104) and the Left Handrail (not shown) with four #8 x 3/4" Screws
(1)(only two are shown). Make sure that no wires are pinched. Start all four Screws be- fore tightening any of them; do not over- tighten the Screws.
8.Start a 1/4" x 1 1/4" Bolt (10) with a 1/4" Star Washer (14) into the bracket and the Crossbar
(102)on each side of the console assembly (only one side is shown). Do not fully tighten the
Bolts yet.
Remove the wire tie from the console wire and the plastic ties (only one side is shown). If neces- sary, press the Cage Nuts (74) back into place (only one is shown).
7 | Console |
|
|
104 | Wire | 1 |
|
|
| ||
|
|
| |
Console |
|
|
|
Assembly |
|
|
|
8 | Console | Wire |
|
| Wire |
| |
Plastic Tie | Tie10 | Bracket | |
|
| 14 | |
Console | 74 |
|
|
|
|
| |
Assembly |
| 102 |
|
|
|
| |
10
