3.

Identify the Right Upright (80) and the Right

3

 

 

 

 

 

 

Upright Spacer (82), which are marked with

 

 

 

80

 

 

“Right” stickers.

 

 

 

 

 

 

Insert the Upright Wire (79) through the Right

 

79

 

 

 

 

 

Upright Spacer (82) as shown. Set the Right

 

Wire Tie

 

 

79

 

Upright Spacer on the Base (87).

 

 

 

 

 

Have a second person hold the Right Upright

 

 

 

 

 

82

 

 

 

 

 

 

87

 

(80) near the Base (87). See the inset drawing.

 

 

 

 

 

 

Tie the wire tie in the Right Upright securely

 

 

 

 

 

 

 

around the end of the Upright Wire (79). Then,

 

 

 

 

 

 

 

pull the other end of the wire tie until the Upright

 

 

 

 

 

 

 

Wire is routed completely through the Right

 

 

 

 

 

 

 

Upright.

 

 

80

 

 

 

 

 

79

 

Wire

 

 

 

 

 

 

Tie

 

 

 

4. Hold a Bolt Spacer (81) inside the lower end of

4

 

 

 

 

 

 

the Right Upright (80). Insert a 3/8" x 4" Bolt (9)

 

 

 

9

 

 

with a 3/8" Star Washer (12) into the Right

 

 

 

 

 

 

Upright and the Bolt Spacer. Repeat this step

 

 

 

80

 

 

 

with a second Bolt Spacer (81), 3/8" x 4" Bolt

 

 

 

12

 

 

(9), and 3/8" Star Washer (12).

 

 

 

 

 

 

Hold the Right Upright (80) against the Right

 

 

 

 

79

81

 

Upright Spacer (82). Be careful not to pinch

 

 

 

 

 

 

the Upright Wire (79). Tighten the 3/8" x 4"

 

 

 

 

 

 

 

Bolts (9) until the heads of the Bolts touch the

 

 

 

 

8281

 

 

Upright; do not fully tighten the Bolts yet.

 

 

 

 

 

 

 

8

 

 

 

 

 

Page 8
Image 8
ProForm 8.5 ZT With a second Bolt Spacer 81, 3/8 x 4 Bolt 3/8 Star Washer, Upright do not fully tighten the Bolts yet