2.Locate the Left Upright (68), which has a name decal in the indicated location. Press a 25mm
Round Inner Cap (20) into the Upright. Press a 2" x 3" Inner Cap (25) into the top of the Upright,
Attach the Left Upright (68) to the indicated Upright Foot (33) with two M16 x 68mm Button Bolts (64), four M10 Washers (53), and two M10 Nylon Locknuts (56). Do not tighten the
Locknuts yet. Make sure that the Locknute are on the same side as the M10 Nylon Locknuts (56) on the Stabilizer (6).
Attach the Left Upright (68) to the Support (7) with two M10 x 93mm Button Bolts (45), two M10 Washers (53), and two M10 Nylon Locknuts (56). Do not tighten the Locknuts yet.
Repeat this step with the Right Upright (not shown).
,_25
53 | Name decal |
| on this side |
45< | 20 |
3.Attach the Inner Crossbar (4) to the Left Upright
(68)with two M1O x 72mm Button Screws (44), a
Support Plate (71), an M10 x 93mm Button Bolt (45), an M10 Washer (53), and three M10 Nylon Locknuts (56). Do not tighten the Locknuts yet.
4, Attach the Crossbar (3) to the Right Updght (5) with two M10 x 72mm Button Screws (44), a Support Plate (71), an M10 x 93mm Button Bolt
(45), an M10 Washer (53), and three M10 Nylon Locknuts (56). Do not tighten the Locknuts yet.
44
44
45
71
45
68,
71
44
6
