8.Push down the seat lever (not shown) on the right side of the Seat Carriage Assembly (10), slide the Seat Carriage Assembly into the Seat Rail (78), and then pull the seat lever back up.
Attach a Bumper (51) to the Seat Rail (78) with an
M4 x 20mm Screw (56). Next, press the Frame Rail Endcap (50) into the end of the Frame Rail (52).
9.The Console (4) requires four 1.5V “D” batteries (not included); alkaline batteries are recommended. Remove the two battery covers from the Console. Next, insert four batteries into the battery compart- ments. Make sure that the batteries are oriented as shown by the diagrams inside of the battery com- partments. Then, reattach the battery covers to the Console.
Attach the Book Holder (23) to the Console (4) with two M4 x 12mm Screws (41) as shown.
10.While another person holds the Console (4) in the position shown, connect the wire harness on the Console to the Upper Wire Harness (42). Insert the excess wire harness down into the Upright (2). Attach the Console (4) to the Upright (2) with four M4 x 16mm Screws (57) and two Console Brackets (80).
Be careful to avoid pinching the wire harnesses.
8 |
|
| |
56 |
| Seat | |
5178 |
| ||
| Lever | ||
52 |
|
| |
|
| 10 | |
|
| 50 | |
9 |
| Battery | |
23 |
| Covers | |
41 | |||
| |||
|
| Batteries | |
4 |
|
| |
10 |
| 4 | |
|
| ||
80 |
| 57 | |
|
| ||
57 | 42 | Wire | |
2 |
| Harness | |
|
| ||
7
