2.RemovetheM10Nut(33),theM10x 50mmBolt 2 (27),andtheshippingbracket(C)fromtheBase (85).AttachaWheel(86)withtheBoltandthe NutthatyoujustremovedDonotovertighten.
theNut;theWheelmustturnfreely.Discard82 theshippingbracket.
Pressa BaseCap(82)intotheBase(85). | 27 |
86
, Identify the Right Upright (78) and the Right Upright Spacer (80), which are marked with
Tie
"Right" stickers. Insert the Upright Wire (77)78 through the Right Upright Spacer as shown. Set
the Right Upright Spacer on the Base (85).
77
Have a second person hold the Right Upright
(78) near the Base (85). See the inset drawing.80 Tie the wire tie in the Right Upright securely
around the end of the Upright Wire (77). Then, pull the other end of the wire tie until the Upright Wire is routed completely through the Right Upright.
78
Tie
, | Hold a Bolt Spacer (79) inside the lower end of | 4 | |
| the Right Upright (78). Insert an M10 x 96mm | ||
|
| ||
| Bolt (5) with an M10 Star Washer (8) into the |
| |
| Right | Upright and the Bolt Spacer. Repeat this | 78 |
| step with a second Bolt Spacer (79), M10 x |
| |
| 96ram Bolt (5), and M10 Star Washer (8). |
| |
| Hold the Right Upright (78) against the Right |
| |
| Upright Spacer (80). Be careful not to pinch |
| |
| the Upright Wire (77). Partially tighten the M10 |
| |
| x 96mm Bolts (5); do not fully tighten the |
| |
| Bolts | yet. |
|
_,8 : 77
79
80
