5.While another person holds the Upright (2) in the posi- tion shown, connect the Extension Wire (68) to the Lower Wire Harness (73).
Push the Extension Wire (68) and the Lower Wire Harness (73) down into the Frame (1). Slide the Upright (2) onto the Frame. Be careful to avoid pinching the Wires. Attach the Upright with two M10 x 74mm Button Bolts (7), two M10 Split Washers (45), and two M10 Nylon Locknuts (33). Do not tighten the
Button Bolts yet.
6.Identify the Left Handlebar (6), which is marked with a sticker. Insert the Left Handlebar into one of the Handlebar Legs (5); make sure that the Handlebar
Leg is turned so the hexagonal holes are on the indicated side. Attach the Left Handlebar to the Handlebar Leg with two M8 x 45mm Button Bolts (50) and two M8 Nylon Locknuts (38). Make sure that the
Nylon Locknuts are inside of the hexagonal holes. Do not tighten the Button Bolts yet.
Insert the Pivot Axle (26) into the Upright (2), and cen- ter the Pivot Axle. Apply a generous amount of the included grease to both ends of the Pivot Axle.
Turn a Handlebar Spacer (47) so that the small arrow on the Handlebar Spacer is pointing toward the floor, and slide the Handlebar Spacer onto the post on the Left Handlebar (6). Next, slide the Left Handlebar onto the Pivot Axle (26).
Slide a Handlebar Washer (55) and a Wave Washer (69) onto an M8 x 25mm Patch Screw (56), and tighten the Patch Screw into the Pivot Axle (26). Then, press the tabs on a Handlebar Cap (46) into the Handlebar Spacer (47).
Assemble the Right Handlebar (8) and the other Handlebar Leg (5) in the same way.
5 | 2 | Make sure the |
| ||
| 45 | wires do not get |
| pinched and | |
33 | 7 | damaged during |
| this step. | |
|
| |
| 68 |
|
| 73 |
|
| 1 |
|
6 |
|
|
|
| 8 |
| Grease | |
| 6 |
|
| 55 | 26 |
| 56 | 47 |
|
| 2 |
| 69 | 38 |
|
| |
| 46 | 5 |
| 50 | |
|
| |
| Hexagonal | |
|
| Holes |
|
| 5 |
7
