ASSEMBLY
Place all parts of the
1.Rrmly hold the Seat Tuba (2) with one hand and the Handlebar Frame (3) with the other. hand. Lift the Seat Tube and pivot the Handlebar Frame to the position shown at the dghL
Make sure that there are two Handlebar Bushings
(41)In the upper end of the Handlebar Frame (3).
Slide the Handlebar (4) Into the Handlebar Frame.
The Handlebar must be tumed as shown. Tighten the four #8 x 1/2" Screws (35) into the Handlebar Frame and the Handlebar.
Pivot the Console Bracket (12) to the position shown.
Push the Resistance Knob (6) onto the shaft on the Resistance Cylinder (5).
2.Locate the Cordage Bolt (9) attached to the under- side of the Seat (7). Insert the Carriage Bolt down into the slot in the Seat Frame (2). Thread the Seat Knob (11) with the 3/8- Washer (42) on'tothe
Carriage Bolt. Slide the Seat to the desired posi-
• tion and tighten the Seat Knob.
packing materials; do not dispose of the pack-
a phillips screwdriver _ | (not |
2
2
3.The Console (13) requires two =AA" batteries (not included). Alkaline batteries are recommended. See the inset drawing. Open the battery cover on the back of the Console. Insert two batteries into the Console. Make sure that the negative
Connect the Reed Switch Wire (33) to the wire on the Console (13). Feed any excess wire into the Seat Frame (2). Insert the Conso!e into the Console Bracket (12) until the tab on the Console snaps into the hole in the Console Bracket.
4
