ProForm 831.288080 user manual Wires are pinched between the Console Handlebar

4. Hold the Console (9) near the Handlebar (16) as	4
shown. Identify the green console ground wire and		Console
attach it to the Handlebar with a Console Back		Wires
Screw (20). Make sure that the console ground		18
wire connector is pointed toward the center of
the indicated hole as shown.	16	33
Next, connect the Reed Switch Wire (18) and the				9
two Pulse Wires (33) to the corresponding wires on
the Console (9).	Hole		20	Console
				Ground
				Wire
5. Attach the Console (9) to the Handlebar (16) with	5
four Console Back Screws (20). Make sure that no
				9
wires are pinched between the Console and the
Handlebar.
		16
		20
6. Attach the Front Stabilizer (2) to the front of the	6
Frame (1) with two M10 x 75mm Carriage Bolts (72)			2
	72	69
and two M10 Nylon Locknuts (45). Make sure that
the Front Stabilizer is turned so the Wheels (69)
are not touching the floor.
			1
				45
7. Slide the Carriage Bar (7) onto the indicated tube on	7	1
the Frame (1). Attach the Carriage Bar to the Frame			17
				71
with four M10 x 25mm Button Screws (71) and four		17
M10 Split Washers (17).				17
		71	17
			7

6