With the help of a second person, carefully raise the Upright Base (97) as shown. Carefully pivot the Hood (123) off.
Locate the Reed Switch (22) and the Magnet (19) on
the left side of the Pulley (18). Turn the Pulley until the
Magnet is aligned with the Reed Switch. Make sure that the gap between the Magnet and the Reed
Switch is about 1/8”. If necessary, loosen the Screw
(23)and move the Reed Switch slightly. Retighten the Screw. Reattach the Hood, and run the treadmill for a few minutes to check for a correct speed reading.
|
| 97 |
| 123 |
|
1/8” |
| 18 |
|
| |
22 |
|
|
| 23 | 19 |
|
| |
Top |
|
|
View |
|
|
PROBLEM: The walking belt slows when walked on
SOLUTION: a. Use only a
b. If the walking belt is overtightened, treadmill perfor- | b |
| ||
mance may decrease and the walking belt may be- |
|
| ||
|
|
| ||
come damaged. Remove the key and | UNPLUG THE |
| ||
POWER CORD | . Using the allen wrench, turn both |
|
| |
rear roller adjustment bolts counterclockwise, 1/4 of a |
|
| ||
turn. When the walking belt is properly tightened, you |
|
| ||
should be able to lift each side of the walking belt 2 to |
|
| ||
3 inches off the walking platform. Be careful to keep |
|
| ||
the walking belt centered. Plug in the power cord, in- |
|
| ||
sert the key, and run the treadmill for a few minutes. | Rear Roller Adjustment Bolts |
| ||
Repeat until the walking belt is properly tightened. |
|
| ||
c. If the walking belt still slows when walked on, please call | ® | |||
|
|
|
| |
PROBLEM: The walking belt is |
| |||
SOLUTION: | a. If the walking belt is | first remove the key | ||
| and UNPLUG THE POWER CORD | . If the walking | ||
| belt has shifted to the left, | use the allen wrench to | ||
| turn the left rear roller bolt clockwise 1/2 of a turn; | if | ||
| the walking belt has shifted to the right, | turn the | ||
| bolt counterclockwise 1/2 of a turn. Be careful not to |
| ||
| overtighten the walking belt. Plug in the power cord, |
| ||
| insert the key, and run the treadmill for a few minutes. |
| ||
| Repeat until the walking belt is centered. |
| ||
| b. If the walking belt slips when walked on, | first re- | ||
| move the key and | UNPLUG THE POWER CORD | . | |
Using the allen wrench, turn both rear roller bolts clockwise, 1/4 of a turn. When the walking belt is cor- rectly tightened, you should be able to lift each side of the walking belt 2 to 3 inches off the walking platform. Be careful to keep the walking belt centered. Plug in
the power cord, insert the key, and carefully walk on the treadmill for a few minutes. Repeat until the walk- ing belt is properly tightened.
a |
b |
23
